Continuous Monitoring - Dual Conductor

50537

• Dual Wire Continuous Monitors provide redundancy; even if one dual wire wrist strap conductor is severed, operator has reliable path-to-ground with the other wire.
• Most advanced means of monitoring the ground path for operators, workstations, and equipment
• Adjustable audible alarm level
• For use with dual-wire wrist straps
• Operator charge detection
• Test for proper calibration with the 50524 Dual-Wire Monitor Limit Comparator
• Made in America

Note: Work surface must have a conductive layer such as Dual Layer Rubber or Dissipative 3-Layer Vinyl or Micastat® Dissipative Laminate with conductive buried layers. Our Continuous Monitors are not recommended for use with homogeneous matting.

50580

• Steady state DC Dual Polarity Signal, leaving virtually zero voltage on the operator
• Programmable monitoring at 200 mV, 100 mV and 50 mV
• One of the lowest test voltages in the industry - 50 mV; exceeds most dual-wire monitoring technology
• Designed for the most critical applications such as disk drive manufacturing and semiconductor fabrication
• Provides continuous ground monitoring of two operators, two supervisors, two workstations and two tool grounded stations
• Features two charge detection indicators that monitor voltage on the operators' circuits
• Dual Wire Continuous Monitors provide redundancy; even if one dual wire wrist strap conductor is severed, operator has reliable path-to-ground with the other wire
• Most advanced means of monitoring the ground path for operators, workstations, and equipment
• Operating Voltage: 100-240 VAC
• Operator remotes are enclosed in stainless steel for better durability and cleanliness
• Made in America

Note: Work surface must have a conductive layer such as Dual Layer Rubber or Dissipative 3-Layer Vinyl or Micastat® Dissipative Laminate with conductive buried layers. Our Continuous Monitors are not recommended for use with homogeneous matting.

50535

• Programs the upper and lower resistance levels of each operator of the Zero Volt Monitor
• Made in America

50524

• Tests the Zero Volt Monitor for proper calibration
• Use the selector knob to select resistance
• Made in America